help help

[death-o-matic]

i need instuctions on how to install a pump kit
on a 2000 wgp autococker

[DeepFreeze]

First, remove the bolt to allow you to remove the back block from the pump rod, then remove the front block by unscrewing the banjo bolt. Also don't forget to remove the timing rod from the trigger plate. After you have done this screw the pump rod into the hole that the banjo bolt came out of. screw the back block onto the new pump rod and you are done. Oh, don't forget to time your new Sniper II....only slightly kidding. You should adjust the hammer lug and trigger to where you you want them.

[El_Griton]

First, remove the bolt to allow you to remove the back block from the pump rod, then remove the front block by unscrewing the banjo bolt. Also don't forget to remove the timing rod from the trigger plate. After you have done this screw the pump rod into the hole that the banjo bolt came out of. screw the back block onto the new pump rod and you are done. Oh, don't forget to time your new Sniper II....only slightly kidding. You should adjust the hammer lug and trigger to where you you want them.

Nicely put.

[bunkermonkey376]

how do you completely take apart an 04 shocker with a freeflow bolt

[Paco]

First, you would start by making a new post as shockers are neither cockers or pumps!
Second, take the air off the gun and remove the barrel.
Then unscrew the cap on the back.
Push the bolt assembly out the back. You may need to use a squeegie.

I think that's about it, then again, I'm going from memory and I can't be 100% sure that I haven't left out anything. Just go slowly. If you have to force anything then stop.