PDA

View Full Version : hey

colin2722
02-25-2008, 03:52 PM
does anyone know if you can put a black dragun electric frame on a spyder body?
KTOninjaSNIPER
02-25-2008, 04:22 PM
90% sure you can....try it.
colin2722
03-09-2008, 05:58 PM
ok new question but i wont cluter the board with a new thread so here goes.

my black dragun is pretty much an electric spyder because i switched some parts off my spyder and everything fit fine so ill base it on that. the gun will shoot one shot and then act like a gun out of air so i thought it might just not be catching but i replaced the screw so i dont think its that. it does have an electric trigger frame so it is electric. if anyone has any suggestions/advice im extreamly open. thanks

Colin
orange ion dude
03-09-2008, 06:01 PM
Is there a way that the dwell is set to low? That is what I have had happen to me many times.
clark
03-09-2008, 06:14 PM
Are you shooting paint or just dry firing?
m0rning4est
03-09-2008, 06:24 PM
i don't know much about spyders but dont they need blowback pressure to work?
KTOninjaSNIPER
03-09-2008, 06:55 PM
like clark and JJ said. you need to be shooting something. if you dont have any paint, take ur barrel off and hold your palm over the breach tightly.. shoot and the back pressure should recock the bolt and hammer. another thing also. take the oring off the hammer(the part the spring goes into and the bolt connects to) this oring is useless and causes more drag than anything.

disreguard what orange ion says. spyders dont have a "dwell" setting. in a way, adjusting the velocity in a spyder would be the same as adjusting "dwell" since increasing the spring tension would cause the hammer to "dwell" on the valve longer.
baller544
03-09-2008, 07:49 PM
i don't know much about spyders but dont they need blowback pressure to work?

it does...and the problem could be as simple as needing to lube it(worked for my spyder back in the day)

Are you shooting nitrogen or co2?
colin2722
03-09-2008, 09:49 PM
ive replaced all the orings lubed and cleaned everything. the problem has been while shooting paint so im not dryfireing it and im shooting nitrogen.
DM5KILLA
03-09-2008, 10:07 PM
ive replaced all the orings lubed and cleaned everything. the problem has been while shooting paint so im not dryfireing it and im shooting nitrogen.

did you remove the hammer o-ring?...
KTOninjaSNIPER
03-09-2008, 10:54 PM
LP nitrogen tank? perhaps tank pressure is too low to recock the hammer assembly. Spyders are high pressure guns. if this is the case maybe a lighter mainspring would help. lighter main spring means the lower pressure doesnt have to push as hard to get the hammer back...just a thought tho. never really ran a spyder off LP air. my t boarded spyder i hook a HP tank right up and it worked fine so this is why im thing it must be ur tank.

try the gun w/ a co2 tank or some1 elses High Pressure HPA tank.