eyes for 05 prostock

[smartparts]

I was wondering how you put the eyes of the e2 frame on the 05' prostock. I am planning to get the 05' with e2 frame. Do you have to mill out holes or what. I don't see any spots for them to be put on?

Thanks,
Jared

[pb4life445]

get an 04'!!!!!

[jojo750]

yes you have to drill 2 holes in side of frame. 1 for the eye, and 1 for the eye cover screw. that hole has to be tapped for a small screw. i dont remember the size offhand, but can get it if i find my eblade manual.

[RecBallKing!]

hey...im local and i can drill ur eyes and tap ur eye screw hole...once you get it look me up a PBC and ill do it 4 you 4 a nominal but not outragious fee...

[smartparts]

Ok that sounds good. Thanks for the help everyone. JoJo give me a PM once you find out. I will look you up Recballking once i get my gun.

Thanks,
Jared

[RecBallKing!]

yup
and to help joey out the screw thread is 4-40...

[jojo750]

the eye hole is NO.20 (0.1610" 4.1mm)
the tapped screw hole is NO.43 (0.089" 2.3mm) and tapped with 4-40 unc tap

from the eblade manual. i dont know if there is a download available anywhere, but there is a template in the back of the manual that you can tape on your gun that has the holes already patterned out. you just have to have the right size drill bits.
good luck with it.

[DM5GUNNA]

you can do it locally, or I know that a few companies do it, but you have to send your gun off

[RecBallKing!]

yeah so i got the template the drill press the taps and bits so lmk if and when u need it done...u get it 2 me 1 saturday and ill be able to get it back sunday..later