View Full Version : autococker feed neck?
pb4life445
04-02-2006, 12:22 AM
ok....im am such a noob it isnt even funny....and i am laughing while writing this but how do u take off an autococker feed neck?
Thanks,
Cameron
jojo750
04-02-2006, 10:51 AM
only certain cockers have a removable feedneck. but if there are 2 set screws at base of feedneck, you need to remove those. then unscrew the base from the cocker body.
do you have the clamping feedneck? if so, these instructions should work.
DM5GUNNA
04-02-2006, 11:24 AM
on stock feednecks, just turn it off (like your unscrewin a tank/barrel), but like joey said, some WGP guns dont have removable feednecks.
pb4life445
04-02-2006, 12:33 PM
does the 04' prostock?
jojo750
04-02-2006, 01:02 PM
does the 04' prostock?
i dont know off hand, but if you can twist it counter-clockwise it will unscrew from the body.
do you have a clamping feedneck? if not, then you wont be able to remove it.
pb4life445
04-02-2006, 01:24 PM
nope its not clamping......... :( ........and my egg fits just not as good as i want it to......
jojo750
04-02-2006, 03:00 PM
if there are not 2 set screws at the base of the feedneck, then it is not removable. you will probably have to use tape to keep the egg from moving around. i had to do it to mine too. not a big deal. you can use other stuff to .. piece of paper towel. small piece of t-shirt. whatever will keep the hopper from twisting around.
pb4life445
04-02-2006, 03:05 PM
nah its not too lose just to tight....but i can force it in and it works so no big deal....plus im getting a pump kit and ill use a little brass eagle 50rd hopper....the egg is for when i get my e-blade.......
jojo750
04-02-2006, 04:05 PM
oh..my bad. i assumed the feedneck was too big for the egg. if the egg doesnt fit, most people just sand the feedneck on the egg down until it fits the marker.
sorry about that.
Not 100% sure but it looks like it's removeable from pics I've seen. The main part of the feedneck is like a sleeve that screws down onto the body. It's really hard to see if it's a seperate piece or not but I believe all the stock cockers from 02 or 03 up have had the threaded vert feeds. You may need a strap wrench to unscrew it the first time but it should just twist up and off. Again, not 100% on this model so be gentle.
SuPeRmAn
04-07-2006, 09:51 PM
i think it does use a strp wrench
RecBallKing!
04-07-2006, 10:35 PM
thats a big negatory if its just a 04 prostock body...ur gonna have to get it sent off...unless they changed sumthin, then try lookin at the feed neck from the bottem side...if there like a fine line that makes it look 2 pieces then its removeable...if not then its 1 piece and pullin and yanking on it is gonna remove that whole feed tube assembly...