Dye Twist Bolt and Block

[guitarmaster1195]

How do you get the Dye bolt out of an autococker? I know you are supposed to twist it and pull it out, but when I turned it, it only came out half a centimeter when it was turned all the way to the left. What am I supposed to do to get it out?

[RecBallKing!]

its acctually a systemx cocker u got from john...not a dye...but its the same principle of turning and pulling...maybe ur doin somthing wrong

[SuPeRmAn]

i would turn it and do a move many have done for years use a squeegee and ram it haha

[guitarmaster1195]

yea i know its not a dye autococker... its the bolt, but i was still wrong i guess it's a system x; w/e it still shoots really good. I turn it to the left and it clicks out a tiny bit. Am I supposed force it out like with a squeegee?

[DeepFreeze]

Yep, they can be pretty finicky at times. That is one of the reasons I personally don't care for them.

[Koz]

Before you twist and pull, pull the whole back block back and then do it...sometimes the ball detent can cause problems...

[guitarmaster1195]

thanks guys- it finally came out. i had to turn it to the right, not the left, and pull out the back block like coz said. it came out and after i ran a squeegee through the gun and lubed the bolt, it turns and comes in and out a lot easier.