Cocker Body

[DM5GUNNA]

I would like a dust black right feed cocker body w/ ASA, preferably 2k+

if you have one lmk

[DeepFreeze]

You should check with Grendel or Thumper at PBJunkie. They always seem to have a few laying around.

[DM5GUNNA]

thanks jamie

[DM5GUNNA]

ok got one thanks matt

[Koz]

Jami did even reccomend his kinda sorta protege...if I spelled that right...

[DeepFreeze]

Matt, I didn't know you had bodies. I know you have plenty of parts but if you have bodies as well I will start throwing your name in as well.

[DM5GUNNA]

btw, matt or deep have any reccomendations on getting pieces of a broken valve tool out (the wgp one sucks lol), and yes all the locking screws are out, its just the little locking nut in front of the valve, i ordered a better one.

[RecBallKing!]

im not matt or deep but maybe a magnet if its steel or iron or nickle or cobalt.

[DM5GUNNA]

i might try that, or just sit there and work it out

[DeepFreeze]

Try a long screw driver, but make sure to tape it up well so you don't scratch the internals of the body.

[RecBallKing!]

also when u put it back together make sure u 4get the valve spring(right jamie ;) ) it will be soo quiet and consistant

[DM5GUNNA]

lol ok i got it out w/ jamies technique, thanks lol, lol yehhhh casey sounds good lol

[RecBallKing!]

seriously...jamie will tell ya that it worked...he couldnt get it to work again but it worked the 1st time until he took it apart again.

[Koz]

Gosh Derek just had to take it apart didnt he, im gonna start leaving valve springs out of guns at the shop...